EICG-5B-DPA-NP
Designed for double pin side tied running angles. Insulators 55-6 Conductors up to 397 Angles up to 40 degrees bisected, 20 degrees on one side, 20 on the other. The bolt on the side of the cap should be located opposite the conductor and when installed will be located under the ear of the insulator. Will fit pole dimensions from 5”-12”.
EVT-1B-DP-NP 5-18 inches
Designed for the Hendrix Vice-Top Insulators double insulator configurations. Will fit pole diameters ranging from 5” to 18”. Center sleeve needs to be trimmed from center of the sleeve to the crossarm width, inside to inside measurment of the crossarms.
Example: Sleeve is 18” in length, inside to inside measurement of the crossarms equals 18”, no need to trim. For a 12” pole diameter trim one side from the end 3” then trim the other end 3”. Total length will now be 12”.
Measure the inside to inside dimension of the crossarms. Or in the case of a ridge pin measure the pole diameter and trim accordingly.